Firmware Menu / 14.3 - User Permissions
allows configuration of settings via the MiniHPC display and via On-line cloud without restrictions
allows the user to modify settings only to a limited extent.
The following settings sections are locked:
- 2.5 3-way valve R5
- 3.4 DHW HP conditions
- 3.6 El. heater mode
- 3.7 3-way valve R4
- the entire Calibration menu
- the entire Protections menu
- 13.4 Quiet mode
- 13.5 Defrost control
- 13.6 Defrost trigger
- 13.7 EEV control
The following settings sections are locked:
- 2.5 3-way valve R5
- 3.4 DHW HP conditions
- 3.6 El. heater mode
- 3.7 3-way valve R4
- the entire Calibration menu
- the entire Protections menu
- 13.4 Quiet mode
- 13.5 Defrost control
- 13.6 Defrost trigger
- 13.7 EEV control
- to change between full/restricted access, the correct PIN code must be entered. This PIN is identical to the Password specified in menu 9.2 WiFi AP.
Changing the access restriction also affects configuration change restrictions for On-line cloud with one exception.
If the device is registered to the Cloud portal at a time when full access is enabled, then access through the Cloud portal will remain unlocked even after the access is changed to restricted.
This is important for installation companies that want to retain full access to the device through the Cloud portal while setting restricted access for the end user.
In this case, the installation technician must first add the device to their own account, then enable restricted access, and only afterwards allow the customer to add the device to their account.
This is important for installation companies that want to retain full access to the device through the Cloud portal while setting restricted access for the end user.
In this case, the installation technician must first add the device to their own account, then enable restricted access, and only afterwards allow the customer to add the device to their account.